Cart 0


  • $ 49.99

Item Number: LUM6978

Key Features

New BusyBee2 MCU at 48MHz, up to 500k eRPM support
Improved firmware using BLHeli_S
Hardware PWM driver at 36KHz
Supports DSHOT, Oneshot125 (125-250us), Oneshot42(41.7-83.3us) and Multishot (5-25us). Auto-detection
Lightweight, and compact size
Adaptive timing, compatible with a wide range of motors and Kv
Sychronous rectification technology adds efficiency, damped light
Powerful regenerative braking / active braking
3-6s LiPo battery compatible
DSHOT compatible!

What's in the box?

(1) Lumenier BLHeli_S 30A 4-in-1 OPTO DSHOT ESC +Current Sensor
(1) Signal wire connector with servo connections (130mm)
(1) 14AWG Silicone wire and XT60


The Lumenier 4-in-1 30A Blheli_S ESC with Current and Voltage Sensor with BB2 chip features the powerful BusyBee2 (EFM8BB21F16) chip that runs at at 48MHz 2x the speed of prevoius BLHeli_S ESCs. This BB2 processor allows the ESC to perform with incredible precision (up to 500kv eRPM support), resulting in smooth and responsive power and taking full advantage of the BLHeli_S firmware.

This 4 in 1 ESC is low profile and compact in size, saving weight and making builds easy. These ESCs are OPTO (no BEC) and come with motor, signal and power wires for your convenience. The set also includes 14AWG wire with a XT60 connector. The ESC features new BLHeli_S firmware pre-installed on them and is DSHOT compatible out of the box. It is also compatible with PWM, Oneshot125, Oneshot42, and Multishot protocols. Simply enable the feature in the flight controller software and the ESC will automatically match it.

These BLHeli_S ESCs feature hardware PWM controllers running at 36KHz, which is more than double of previous software PWM ESCs at 16KHz. This results in ultra smooth throttle response and near silent motor operation.

Signal Wire Pinout:

No Connection
Current Sensor
Voltage Sensor


Input: 2-6s Lipo
Constant: 30 Amps
Burst: 40 Amps
Onboard Current Sensor: 150A
Weight: 14g w/ wires
Dimensions: 40x37x6mm (7mm tall including connectors)
Mounting Dimensions: 30.5x30.5mm
Motor wire: 70mm
Signal wire: 140mm
MCU: BusyBee2 MCU at 48MHz
PCB - 4 Layer Blind Pole PCB - 3oz Pour
Mosfet: N-Channel
BEC: OPTO (none)
Voltage Sensor

We Also Recommend